BB Talkin Waterproof Helmet Headset Single Sided

Waterproof helmet headset with single speaker over left ear by BbTALKIN USA.

This headset fasten to your helmet by a marine grade Velcro. Designed to be installed on a water helmet with open ears, not rubber coated. Please make sure you have a flat surface to install on.

To be used with our BbTALKIN units. You plug the headset’s 3.5mm audio jack directly into your unit for communication.

Boom microphone has replaceable microphone and speaker if corrosion starts to build over time when used in salt water.

Specifications

Waterproof helmet headset with left speaker and microphone:

When adding the Foam Ear Pads you will receive:

How to Maintain

1. Use fresh water to wash all of the headset.
2. Make sure to rinse the microphone and speaker piece.
3. DO NOT use high pressure spray.
4. It is best to submerge in a bucket of fresh water for a through wash.
5. Hang to dry in a well ventilated climate controlled (a/c) environment.
6. Over time, the male 3.5 jack on the headset may become corroded.  (dull in color)  Make sure to keep this clean by a cloth or scotch bright.  Do not use any cleaning solution. It is best to keep the headset plugged into your unit if possible to help avoid corrosion build up.

How to Use

If using in salt water, you must fresh water rinse. Failure to do so can cause corrosion and product failure.

1. Use the alcohol prep to clean up the helmet surface. You must clean the surface of your helmet to insure the 3m tape will adhere to the surface. The 3m tape will not adhere to rubber surfaces.

2. Attach the helmet speaker pad Velcro tape onto the helmet, left side, just above the helmet ear opening.

3. Run your helmet strap through the elastic band on the helmet speaker pad. This is important! Failure to do this step can cause the rubber to rip on your helmet speaker pad.

4. Install the plastic mount onto the left side of your helmet, just above the headset. (The rubberband helmet mount comes with your Advance Unit set)

5. Stretch each rubberband around the waterproof case and secure the band to the bottom of the mount.

6. Plug in the 3.5mm audio cable. Make sure the cable is tight and secure. Failure to do so will cause water intrusion into the casing. Any water damage to the unit is not covered under warranty.